wicked curve complete CDI ignition kit for garelli NOI

$239.99

qty:

here's what ya get in this PARTYYY!:

4 of BLUE 16-14 gauge electrical spade connector - female ($1.96 value!)
2 of M6 allen bolts - plain finish - 25mm ($.69) ($1.38 value!)
1 of parmakit cdi box with wicked ignition curve for sooo many bikes ($70.99 value!)
1 of wicked CDI stator ($69.99 value!)
1 of wicked CDI stator plate - 80mm ($34.99 value!)
1 of wicked CDI flywheel - garelli NOI ($107.99 value!)
2 of wicked M4 x 12mm low profile screw ($1.98 value!)

this ain't yer run of the mill CDI bubby boy....this is a lovingly curated collection of bespoke gizmos and techno-wizardry sure to please any mopedder. OEM quality euopean products ensure many years of reliable spark and lighting! this 12v CDI features 90w of accessory power that will allow you to fulfill even your most wild fantasies. with wicked curve CDI box this ignition will keep your temps at bay! designed to be ran as a 12v AC or DC system depending on which regulator/rectifier you end up choosing. amazing!

for garelli NOI !!! apparently this will NOT work on garelli 2 speed automatics. if you have anything other than a single speed garelli noi please proceed with caution and ask us anything you might need to know.

note this CDI does not use a woodruff key! you will need an ignition micrometer or other accurate piston depth measuring method to properly install and time it. flywheel features dual timing marks for clockwise and counterclockwise rotations.

uses a 19 x 1.00mm flywheel puller!!

wiring:
red goes to CDI box
blue goes to ground
yellow goes to regulator/lights
white goes to accessory (see instructions!!)

you will need a 12v voltage regulator to keep your lighting system happy. if you want to stick with an AC system, something like the trail tech dial-a-brightness is a great option. if you are planning on running DC grab a wicked reglator rectifier here!!! the cool thing about the wicked regulator rectifier is that you can run it as a DC half wave rectifier or as an AC regulator!! amazing!

note the flywheel cover will NOT fit the larger rotor without a little spacing. just slap a couple washers in between the case and flywheel cover to gain the necessary clearance!

comes with stator, stator plate, stator plate mounting screws, flywheel, and wicked curve CDI box!

universal CDI box mounting brackets available!!!

does not come with a flywheel nut or spark plug boot!!

flywheel weighs in at an impressive 470g!!

here are some other ignition flywheel weights for comparison:

HPI mini rotor = 345g
powerdynamo = 710g
bosch points flywheel = 838g
treats cdi = 886g

90mm OD flywheel

INSTRUCTIONS!!!

rate this moped part be the first!

treatland