taco eater :
MickeyHaddox from INDIANOLA, IA United States
Fit my vm18, but needed trimming to fit on an NU50. However, be aware the neither the miniest knarp nor the mini knarp seem to work with this. The mini knarp atleast fits the cable, but is slightly too wide to work in the nu50. The miniest knarp doesn't even take the cable.
Was this review helpful to you?
1 taco eaters like this review
Works with a TM24 on a 1980 QT50
January 24, 2023
taco eater :
Adam Rogers from versailles, KY United States
although not a perfect match for a QT50, with a bit of rigging and splicing and some local hardware store bits, I managed to keep the 10mm fitting that screws into the right handlebar, with the whole length of cable in use. note: in my case specifically, there is a shoddy attempt at a cable adjuster using a barrel screw at the handle, and no cable adjuster at the carburetor. be advised.