vespa piaggio malossi RHQ racing crankshaft - 12mm wrist pin
vespa piaggio malossi RHQ racing crankshaft - 12mm wrist pin
 
  $264.99

 :HERE NOW!!

Free Shipping
qty:

 
 
malossi race crank for all vespa piaggio mopeds such as ciao, bravo, grande, SI, boss, grillo and citta!! fully heat treated and reinforced! dynamically balanced for smooth operation up to 16k rpm! wow!!

12mm wrist pin!!

comes with the small end needle bearing, crankshaft nut and woodruff key!

WARNING: assembly with original crankcase (art. 5319434 - 5319440) Prior to proceeding with the new crankshaft assembly, it is necessary to machine the crankcase as shown in Fig. 9 (see instructions!!) to allow the crankshaft to rotate completely. Prior to machining, it is recommended to mount the new Malossi crankshaft into one of the crankcase halves, the cylinder and the piston and verify approximately the area to machine.

5319434

taco rating taco rating 1 of 5 1 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
1 of 5 does NOT work in stock cases. October 3, 2024
taco eater : Maize from on my way to the moon.  
I thought this would be a great aftermarket balanced crank for a stock case build. I was wrong.
The con rod hits the intake window as well as the crank lobe. Crank will NOT rotate in cases.

The con rod is over sized and also hits the cases on the down stroke so you have to dremel your cases.

I made a post about it with photos on MA. https://tinyurl.com/2dgvydph


Maybe its GREAT on a aftermarket case. IDK.

Was this review helpful to you?