taco eater :
brian schulz from Evanston, IL United States
Works great. only 1/4 turn and your at full throttle. Pulls the PHBG slide full open without issues. Excellent quality
Was this review helpful to you?
0 taco eaters like this review
Adequate quality, but it works
October 22, 2015
taco eater :
blackumi from Moreno Valley, CA United States
Gets the job done.
Use the mini knarp, and grease the moving pieces so the the feel is a little more solid.
May need to trim the grip area down a bit. My grips were too short for it and I didn't realize until after I put it. Scared to take it off for fear of breaking the throttle.
Will update if this assembly dies before I get a new one.
I will say, this piece is very easy to install and service.
Was this review helpful to you?
0 taco eaters like this review
Just OK.
August 17, 2012
taco eater :
Jim Shup from Portland, ME United States
It works but the quality is junk. I'll see how long it lasts. I have a much nicer billet aluminum one with a bearing wheel that I paid $25 for. Much nicer than this and will last forever-ever-ever-ever.......etc.
Was this review helpful to you?
0 taco eaters like this review
real good
March 23, 2012
taco eater :
tim ostrom from savannah, GA United States
i've been using old used junky magura controls on my puch for a long time. they were always loose, and always broke in the same spot. this thing is kinda big, seems very sturdy, and opens up my 15 bing in like 1/10th of a turn. kinda funny when wot is only a hair away from closed. it has a pulley inside it for the cable and seems like it will make the cable last a lot longer. if your narp rubs, just file it down a little. i put some grease in mine for super smooth twistyness. will open up the biggest of big carbs. average sized brake levers do fit around it.
Was this review helpful to you?
0 taco eaters like this review
great for the price
November 27, 2011
taco eater :
Baltard Chris from Baltimore , MD United States
perfect for simplifying controls on a bike. good for the price. you need to make sure the knarp goes in the correct way. and is super tight! but its pretty simple to work on.
Great short pull throttle assembly 
Adequate quality, but it works 
Just OK.