tomos moped a55 70cc airsal cylinder with head
tomos moped a55 70cc airsal cylinder with head
 



  $149.99

 :HERE NOW!!

Free Shipping
qty:

 
 
tomos 70cc 44mm cylinder for the A55 tomos engines found on the late and current model tomos mopeds!

if your case doesnt already have m6 / m7 studs, you will need to get these tomos studs here!! the stud holes on this case will not fit m7 size studs, and these special ones thread in m7 and taper down to m6

fits perfectly and works with your existing carburetor, intake, and exhaust, as long as you upjet your carburetor. Be sure to use the 6413 6mm dellorto main jets if you are using the original PHVA carb.

comes with cylinder, head, piston, cast iron ring, chromed ring, wrist pin, clips, and gaskets.

this head uses a regular short thread bhs spark plug.

01210444

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 16 give your taco rating here

  0 taco eaters like this review
 
3 of 5 Meh (maybe) August 13, 2023
taco eater : Matthew Mulligan from terryville, CT United States  
Head was weird out of the box, casting texture in combustion chamber and weird sharp angles, so I polished it up a bit. Otherwise just matched transfers and polished the exhaust port a bit. Geared 27/24 on a streetmate with a 3" knobby, phva 17.5, 18mm intake and estoril sidebleed. Honestly, my ported stock cylinder was faster. I gained low and mid range and have better hill climbing, but I had to swap rear sprocket from 26 to 24 to gain my top speed of 44-45 back and it's much weaker on top.

Update: still 3 stars because that head is weird but I found a massive oil leak at the case gasket and suspect an airleak, will update review again upon rebuild.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Beautiful Engine February 16, 2023
taco eater : Nelson from Wise, VA United States  
As far as installation it has been a breeze, still haven't had a chance to run it, will provide and updated review later.

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 This is Hot Sauce you need April 27, 2020
taco eater : Enchilados from Grand Rapds, MI United States  
This kit installed perfectly in 2011 Streetmate with stock exhaust, intake and carb.  22 tooth sprocket added next. Moded muffler for fun but was not enough. MLM sidebleed added and bam, now stock carb is limiting the good times(speed 44gps). 18mm  Mikuni kit is on the way...

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 ? October 4, 2017
taco eater : william from wilmington, NC United States  
Will this work on an 86 a3

Was this review helpful to you?

  3 taco eaters like this review
 
5 of 5 MOPED RIPPAGE September 16, 2017
taco eater : B doorn from Long valley, NJ United States  
This kit is Most definitely the best drop in kit ever...opened up the transfers a bit and Woah hold on! With the kit, 19mm phbg, Treatland hammer clutch, homoet p6 and 28/22 gearing I get as high as 58mph with good acceleration on my streetmate R

Was this review helpful to you?

View All Customer Reviews