taco eater :
Michael Hartman from Omaha, NE United States
had an exhaust stud snap on me when installing the pipe. definitely order some aftermarket studs fot his kit! otherwise awesome kit with no problems, gaskets are quality and reeds are good.
Was this review helpful to you?
1 taco eaters like this review
Watch those exhaust posts!
July 10, 2018
taco eater :
Dewey from Louisville, KY United States
The exhaust post that come with this kit are shit soft! Stripped almost as fast as your mom did at my house last night. SERIOUSLY!! Go ahead and get the copper posts. Other than that super easy install.
Was this review helpful to you?
0 taco eaters like this review
Basic Kit
March 15, 2016
taco eater :
CB from Eustis, FL United States
I threw this kit on in an afternoon. The nikasil was chipped on the bottom of one skirt. Came that way in the plastic. Will see how it holds up. The casting quality isn't awesome on this but its a decent enough kit I guess. Started on the first kick. Gonna go easy on it for a hundred miles. Running a 14.14 with 76 main for now. Screen filter/cap, c7 plug, a55 airsal 44mm head with .4mm aluminum head gasket. I ditched the reeds that came with this kit and used a polini reed kit. Sounds and feels killer so far.
Was this review helpful to you?
2 taco eaters like this review
So far reliable.
March 26, 2014
taco eater :
traylor from tallahassee, FL United States
I want to preface this by saying I'm only 350 miles in to this kit. I have a 15:15 sha 15mm intake ported, polini reeds, tecno estroil, high comp head, probably something else I'm forgetting.
I did the 200 mile break in and then took it straight to a rally. After 60-70 hard miles of running pretty full blast I can say that the kit seems to run comfortably around 280-320 degrees and when you're full throttle for long periods of time I was seeing 360-380, but thats after already running for 40 miles and going 45mph for a few minutes. Keep in mind I'm not running a big carb and intake so you might want to watch those temps or seize. I built this bike to be a really reliable in town moped. I'm assuming you can blast on this kit if you put an MLM, 24mikuni etc etc. but if you want a really reliable set up this kit is pretty cool. Not much room for case matching imo (I run an a55 bottom end)
I'd buy it again.
Was this review helpful to you?
0 taco eaters like this review
This kit rips!!!
May 19, 2013
taco eater :
brandon koshak from cookstown, NJ United States
Threw this kit on my sprint and was thrilled at the speed of it. Along with the puch high comp, it's fast.