puch magnum footpeg conversion set

$45.00

qty:

here's what ya get in this PARTYYY!:

2 of metric external circlips - 17mm x 1mm ($1.50 value!)
1 of doppler clutch pulley pedal shaft for peugeot ($25.00 value!)
1 of buzzetti moped black foot pegs ($25.00 value!)

fits on any puch magnum or freespirit frame. comes with:

- highest quality doppler pedal shaft

- rad buzzetti pegs

- (2) 17mm circlips

the shaft does not have a pedal sprocket. put the shaft through the normal pedal shaft area, and then install the circlips so that the shaft does not slide from left to right. you may need a small spacer anywhere from 5mm to 10mm for maximum placement of the shaft. slide the pegs on, and make sure that when you tighten them down, the allen bolt on the peg goes into the slot where the cotter pin would have gone. this makes it so that the bolt is flush on the peg, and ends up looking stock when you are all finished!

taco rating taco rating 4.5 of 5

4.5 of 5 Total Reviews: 2 give your taco rating here

0 taco eaters like this review

Should do the trick	September 11, 2019
taco eater : Shane Johnson from United States

If you don’t want them to spin you can drill the pedal shaft collar and tap a set screw. Day 2 level Moped stuff.

Was this review helpful to you?

1 taco eaters like this review

Sick	March 9, 2012
taco eater : fox Iv from dopetown United States

they dont slide left to right, what about spinning? do they spin? i bet they do. spinning pegs is dumb, i would know. still tho might get these and solve the spins myself.

Was this review helpful to you?

treatland