ATOMIC - puch sealed bearing 5 star rear wheel bearing spacer
puch rear wheel sealed bearing spacer
 
  $11.00

 :*sorry none today*

Free Shipping
qty:

 
 
these little pieces o pipe are a necessity for sealed bearings to work right and stay in place under extreme conditions. and these ones are made by our friends at ATOMIC mopeds

may work on other mopeds as well, check your measurements. this one here is designed for puch five star rims specifically.

so if you're rebuilding your rear wheel sealed bearing set up, and you need this piece, here it is.

or maybe you're trying to adapt a loose wheel over to sealed bearing, you will need this as well.

length = 70mm
OD = 19mm
ID = 12.4mm

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
5 of 5 fit April 15, 2017
taco eater : moped man from portland, OR United States  
had to trim it to fit my spoke wheel hub works great

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Cool! November 5, 2013
taco eater : Anonymous Person from Detroit, MI United States  
But 70mm is not long enough for a Puch 17" spoked rear wheel.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Good enough June 9, 2011
taco eater : michael cohen from Medford, MA United States  
Why mess with some random pipe from the hardware store that might not do the job? I Cut theses down to do snowflake conversion and front 5 star. So far so good.

Was this review helpful to you?