treatland

puch 38mm O-RING high compression head
	$37.99 qty: here's what ya get in this PARTYYY!: 1 of replacement VITON o-ring for 38mm - 45mm heads ($1.99 value!) 1 of new style puch 38mm ORING head ($37.99 value!)

finally theeeeee 38mm O-RING high compression 50cc head for puch maxi magnum pinto free spirit kromag swinger dart tomos yamaha chappy whaaaattttttt!!! its what you've been waiting for your whole life !!!! no MORE head gaskets!! just this O-RING !!!!! --take note these heads DO NOT work on some cylinders that have a decomp hole or that don't have enough surface area to seal properly, if you have any of these cylinders this head will not work - stock A35 cylinder, puch airsal 38mm, 44mm and 45mm, puch polini 64cc-- sealing surface is 53mm so anything wider than that will work perfecto! taco rating 4 of 5 Total Reviews: 7 give your taco rating here

0 taco eaters like this review

Doesnt work with treat kit May 13, 2016 taco eater : Edgar Massey from El Cajon, CA United States   I put this on the treat kit v1 and it blew first ride, but I can use my tomos head without a gasket and its fine so... Don't use with treatland kit. Was this review helpful to you?

1 taco eaters like this review

Uuummmmm.... November 29, 2015 taco eater : Daevy O. from Providence , RI United States   Fits great on my stock e50 with biturbo pipe torqued to 7pds. Love the oring however three star rating cause it was not bolt and go.... Because of compression head my bike has run VERY HOT. Upjet and it 4 strokes.... Very frustrating as it totally gives me the low end I was looking for.... The only options I've heard from moped army are jetting which is def dialed (not my first rodeo) and retarding my timing .... Why!!!!!!! Still a nice head and may work for some... But if I had to do it again wouldnt buy as I was looking for an easy fix for low end. Any suggestions would be great! Or I'll be selling on cl and giving the hi comp a try. Was this review helpful to you?

0 taco eaters like this review

fits on a55 March 26, 2015 taco eater : Christopher Stawski from Montreal, QC Canada   Head is slightly smaller then an a55 head, however it still fits nicely. Super high compression and no more damn leaky gaskets. Ring OD is 51.5 mm Was this review helpful to you?

0 taco eaters like this review

oring March 12, 2015 taco eater : Tom King from Central Point, OR United States   oring needs be high heat    red or org Was this review helpful to you?

0 taco eaters like this review

Yikes September 30, 2013 taco eater : Mark from Rochester, MN United States   Put this on mine Tomos Targa A35 in 5 minutes, and the 0-ring was blew in less than that riding. Had to order  a new ring and hope that it doesn't happen again (only a 1.50 so not too bad its only the time). it is considerably smaller then the Tomos block and is not black to match but I really like the look of it for some reason. i thin it gave me more low and power and with the techno circuit pipe i have low to high end. It turns out the stock Tomos Block flat surface is not a large enough diameter to match the space needed by the flat surface of the O-ring. Mine is only 1 mm off and that is why they kept blowing out! Was this review helpful to you?

View All Customer Reviews