polini performance variator for ++ honda DIO + kymco sniper

$99.99

:*sorry none today*

qty:

polini performance variator for -

BSV : ZX 50 - ZX 50 MOD. 94
HONDA : DIO 50 ZX - DIO 50 ZX ORIZZONTALE
HSC : SC01 50 L
KYMCO : KXR-MXU 50 - MXER-MAXXER 50 - SNIPER 50 DD
SYM : DD 50 2T

"NEW AND IMPROVED DESIGN ALLOWS PULLEY FACE TO SIT CLOSER AS WELL AS EXTEND FURTHER AWAY FROM THE RAMP PLATE. THIS VARIATES YOUR GEAR RATIO EVEN FURTHER GIVING YOU BETTER LOW END POWER WHILE AT THE SAME TIME ALLOWING DRIVE BELT TO RIDE UP HIGHER ONTO THE PULLEY FACE GIVING HIGHER TOP SPEEDS! INITIAL REPORTS ARE 5+ MPH GAIN!"

"ANOTHER IMPORTANT CONSIDERATION IS THAT SINCE YOUR DRIVE BELT WILL BE RIDING UP HIGHER ON THE PULLEY FACE YOUR ENGINE WON'T BE REVING AS HIGH AT FULL THROTTLE. THIS "OVERDRIVE" WILL SAVE YOU GAS AND ULTIMATELY EXTEND THE LIFE OF YOUR ENGINE IN THE LONG RUN!"

***NOTE this will fit honda AF16 AF18 engines but the variator may not clear the electric start housing portion of the engine case. you can either clearance the case or lathe down the OD of the variator.***

comes with variator, ramp plate, plasic guides, shaft collar + 6.3g weights and 7.7g weights. uses 13 x 16 roller weights

polini part number 241.520

rate this moped part be the first!

treatland