polini CP carb METAL adapter for 60mm air filters

$37.99

:HERE NOW!!

qty:

adapter flange so you can use any 60mm ID air filter for your polini CP carburetor!

just slide it over the air filter spigot and then you're ready to mount any 60mm ID air filter you like!

this version is metal and has set screws to hold it in place, thanks polini

inner diameter where the it mounts on the carb is 47mm

343.0028

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 1 give your taco rating here

0 taco eaters like this review

This is actually metal/weighted for a reason	May 16, 2021
taco eater : Mike Boyd from Los Angeles, CA United States

"The Polini CP carburetor is lighter than other carburetors available on the market and under certain conditions it may cause fuel emulsion problems. Air bubbles are sucked into the main jet casing very serious problems to the engine that becomes poor despite having a big or correct jet; the engine begins to detonate up to its break.
Fit the transparent bowl (cod.343.0029) that will allow you to detect the problem and, if necessary, soften the rubber manifold until the problem disappears.
If the problem persists, increase the mass of the carburetor mounting the filter coupling iron flanges (THIS PRODUCT, cod.343.0028) produced by POLINI. Once the problem has been solved fit the standard bowl again.

Was this review helpful to you?

treatland