taco eater :
Mitchell Hoover from San Jose, CA United States
Im using this beef boy for my 40mm Bidalot kit on my pug, it fit perfect. It looks amazing, haven't run the engine though. I imagine it would work on alot of kits so measure and go for it.
Was this review helpful to you?
0 taco eaters like this review
Work on Giraldoni and Athena if you sand a little
June 6, 2018
taco eater :
Puch lover from MOUNT-ROYAL, QC Canada
It fit the Giraldoni 74 cc and Athena 70 cc red valve pistons if you sand the bearing eadge a little bit on a thin sand paper on a flat surface, instead to work into the piston were you have not a good control.
Was this review helpful to you?
0 taco eaters like this review
Fits Puch AJH
May 4, 2015
taco eater :
Maci Dub from Dubvue, WA United States
Got about 17mm between the bosses in the DMP AJH piston and this bearing works perfectly without worry of it walking out too far.
Was this review helpful to you?
1 taco eaters like this review
Very Nice Bearing
March 24, 2015
taco eater :
Sean Lynch from Tucson, AZ United States
It'll fit a TCCD 70 piston with a bit of cleanup in the piston.
Was this review helpful to you?
1 taco eaters like this review
great bearing
October 26, 2013
taco eater :
sean t from san jose, CA United States
I don't need to tell you that wiseco=superior quality. This particular needle bearing works perfect with the treats reed kit.
Works great on Peugeot Bidalot kit 
