METAL valve stem for tubeless tires
metal valve stem for tubeless tires
 
  $9.25

 :HERE NOW!!

Free Shipping
qty:

 
 
metal valve stem for use with no tubes! this valve stem will work with wider rims, will not work with some moped size mag wheels, make sure you check your measurements before purchase. otherwise a great solution to not having to install tubes cause we all know how annoying that can be at times.

length - 33mm

rubber coupler - 16mm width

rubber coupler - 3mm thick

rubber coupler - 12mm insert

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Highest Quality I have seen! May 7, 2013
taco eater : Vincent Hill from Washington, DC United States  
This valve and cap are of the same quality used on my Land Speed Bike. Heavy duty Cap with Seal inside so that when you are going over 150 MPH and Centrifugal force is pulling in the Shader Valve the tire retains full of the air. For the rest of us (not going this fast) this valve may Outlast your Moped. My only complaint is I wanted 4 but they only had "2"! Installed this on the Tomos StreetMate R Wheels and it was a "Perfect Factory Fit"! Now that they have more I am putting them on the Other StreetMate R Wheels.

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 Can work on tomos January 31, 2012
taco eater : coolbic from Minneapolis, MN United States  
Fit newer tomos mag rims (which say they are OK for tubeless right on them) with minor modification.  The stem hole is like 11.25mm on the rim, and this valve stem seal is like 11.75mm.  The description says 12mm, but I had a drill that measured 11.8 so I drilled the rim with the 11.8mm drill bit and the stem fits.

Was this review helpful to you?