|
| |
0 taco eaters like this review
|
| |
 |
 |
 |
|
need cleaning up, but work for pedallin |
June 18, 2020 |
| taco eater :
tdc from Santa Fe, NM United States
|
|
the holes are a bit messy, ideal sometimes but not really for crank arms. nothing a little filing won't set right!
Was this review helpful to you? 
|
|
 |
|
 |
|
| |
0 taco eaters like this review
|
| |
|
|
|
|
Wondeful |
September 20, 2019 |
| taco eater :
Justin Ritchie from Dayton, OH United States
|
|
These fit perfect on my Hobbit with the mlm intake and vm18. Pedal is just short enough to clear the carb.
Perfecto.
Was this review helpful to you?
|
|
|
|
|
|
| |
0 taco eaters like this review
|
| |
|
|
|
|
|
1980 Fantic Pepi - minarelli v1 |
June 3, 2019 |
| taco eater :
E from NORTH ANDOVER, MA United States
|
|
Threw these on with no issues at all. 9mm pins went in no problem with the press tool. I approve!
Was this review helpful to you?
|
|
|
|
|
|
| |
0 taco eaters like this review
|
| |
|
|
|
|
|
yup yup |
October 2, 2017 |
| taco eater :
rodney from san francisco, CA
|
|
fit on my puch maxi and demm smily no prob! i used 8.8mm pins...good to get the cotter pin press too so you can get em in tight!
Was this review helpful to you?
|
|
|
|
|
|
| |
0 taco eaters like this review
|
| |
|
|
|
|
these aren't the arms you're looking for... |
June 30, 2016 |
| taco eater :
trickMETRIC from somewhere under the rainbow
|
|
...if you don't have the tools to make these work.
The proper sized cotter pins don't fit smoothly, so those holes need reaming.
The arms don't fit on a 16mm pedal-shaft (most common size), so those holes need reaming.
I suspect the threads will be too tight for the pedals. Good thing I have a pedal tap set.
All-in-all good arms. Unfortunately the manufacturer didn't take into consideration the added thickness of the chrome plating.
Was this review helpful to you?
|
|
|
|
|
|
|
