doppler needle bearing - 12 x 16 x 15
doppler needle bearing 12 x 16 x 15 for crankshaft con rods. stock size for garelli NOI.
 
  $15.99

 :HERE NOW!!

Free Shipping
qty:

 
 
doppler needle bearing for crankshaft con rods. i think you can use this size to adapt a motobecane crankshaft like the doppler endurance crank to use a 12pin piston, for insane race bikes and things. right? and use for yamaha zuma scooters. also stock size on garelli NOI with 60cc or greater cylinders ONLY.

12 x 16 x15

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
5 of 5 TRAC ENGINES - DAELIM DP50-E July 12, 2020
taco eater : Michael Mills from Worcester, MA United States  
This is the one you want for Daelim single speed engines on trac mopeds. Havent tried the two speed DK motor but it does work in the single speed DP motor. Running a minarelli overbore piston , Honda Nu50 cylinder and a tomos a3 clutch with a yellow spring so the brass Bushing really didnt holdup to the absurd revs. This bering is the key to that equation.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Fits fine on stock July 30, 2018
taco eater : Trenton from Owosso, MI United States  
No issues fitting on either of my stock noi bikes(SSXL and Gran Sport LTD). Both are factory 30mph versions so not sure if that matters.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Garelli owners - Only use with a kit July 19, 2012
taco eater : Anonymous Person  
This does work in Garelli NOI motors with a polini or malossi kit. But its too wide for the stock piston. if you want to use the stock piston and this bearing you will have to file the inside of the piston so it is wide enough for this bearing to fit.

Was this review helpful to you?