Stage6 peugeot 70cc 46mm cylinder kit
Stage6 peugeot 70cc 46mm cylinder kit
 
  $184.99

 :*sorry none today*

qty:

 
 
Stage6 70cc 46mm aluminum cylinder kit for peugeot mopeds + honda PK50 wallaroo and peugeot fox!

no decomp, huge transfers, auxiliary exhaust ports, single 1mm ring piston! awesome!

TECHNICAL HIGHLIGHTS STAGE6 CYLINDER FOR PEUGEOT MOPEDS:

- Optimized cylinder filling thanks to revised transfer ports
- Three-piece exhaust for durability
- Ultra-light piston with 88 grams for maximum power output
- Racing cylinder with over 12 hp

STAGE6 has put all its know-how into this cylinder to set new standards in terms of performance and durability - the racing cylinder for Peugeot 103.

STATE-OF-THE-ART TECHNOLOGY FOR VINTAGE MOPEDS

In keeping with the history of the Peugeot 103, most of the products on the market today are "old" products that were developed and released decades ago and which also deliver a performance commensurate with their time. STAGE6 has spared no effort or expense to bring a new product onto the market for vintage moped fans that is state of the art and delivers the performance possible today.

DESIGN AND PERFORMANCE STAGE6 RACING CYLINDER FOR PEUGEOT MOPEDS

Elaborately developed, sophisticated transfer ports optimize cylinder filling in every RPM range. The three-piece exhaust offers a large exhaust area without putting strain on the piston rings and thus on durability.

The high-quality ultra-light piston specially developed for this cylinder with a complete weight of just 88 grams allows for maximum power output and for the engine to rev up with ease.

The result is a racing cylinder of the latest generation, with which more than 12 hp is possible without much effort. A new benchmark in the field of plug & play cylinder kits for Peugeot 103!

includes everything in the photo plus wrist pin and wrist pin clips (not shown)!

need a spare ring? find one here!

need a spare gasket set? find one here!

the piston included no longer accept needle bearings WIDER than 15mm!! make sure that you are using a 12 x 15 x 15 needle bearing

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Yesss Bro. August 13, 2024
taco eater : justadude from Santa Rosa, CA United States  
4 stars cus the wrist pin included is 1.5mm too long. gotta cut it down in order to get cir-clips installed.

150 miles on this kit at time of writing. Initial impression is that it is the fastest bolt on Peugeot kit I've tried so far. It feels like a legit 12hp to me. Noticeably more power than the Airsal I was running, and that kit was a blaster. Temps are nice and low on this too which is rare for Peugeot kits I've tried. So far hit 63mph but probably will max out at 65mph.
Set Up,
19mm phbg
parma box cdi
giannelli blk gun
50cc derbi head with hand cut squish, its high compression.
Malossi Cases.

There is a thread going here.

Was this review helpful to you?