It works, nothing magical, the A+ quality fit a little better but its only a peice of metal with teeth, save ten bucks and dont let it bite ya when your throwing it on
Was this review helpful to you?
1 taco eaters like this review
Loosey Goosey
July 15, 2020
taco eater :
Matt B from Troy, NY United States
The stock front sprocket is nice and tight fitting, the more expensive ones are nice and tight fitting, these are loose, with lots of play back and forth and maybe are a bit thinner so the retaining clip rotates freely while its on, its probably fine but it will cause more wear to the spline because of this, its just a fact... low tolerances
Was this review helpful to you?
0 taco eaters like this review
For the 18 tooth
May 27, 2016
taco eater :
Countryobtunning from Princeton , MA United States
Make your Dremel and file your best friend. Took me about 20 mins to slap it on a modern 3 bearing case. I got scared, I though I went to deep but it end up being a threaded hole for a magneto screw thank god!
Was this review helpful to you?
1 taco eaters like this review
yesssss
March 6, 2016
taco eater :
daev o. from Providence , RI United States
slapped a 17t on my e50 mag and it went on in less than 2 mins. weighed about same as stock 16t. and when I paired it with 41t rear OHHH NOOOO so fast its scary.... buy this and enjoy!
Was this review helpful to you?
0 taco eaters like this review
Too big for an e50
January 29, 2016
taco eater :
Wesley Brown from Austin, TX United States
I couldn't get the 18 to fit on an e50 even after grinding down the case. Build quality is pretty killer though.
Saul good 
Loosey Goosey 
For the 18 tooth 
Too big for an e50