puch magnum pedal crank shaft

puch magnum pedal crank shaft - 260mm

$39.99

:HERE NOW!!

qty:

use this to get around any pesky things in your way, you know pipes and such.

perfecto for puch maxi, magnum, murray, series B and free spirit!

we now carry a perfect length magnum to maxi spacer if you are installing this on a maxi!! if you are using this on a non magnum you will want to grab some spacers as well.

note you MUST use the special dished washer on the inside of the pedal crank sprocket or else you will have chain alignment issues.

these do NOT work on pinto, swinger and cobra frames as they do not have sufficient inwards dish causing the chain line to be incorrect.

this is the closest replacement for hobbit/camino/pa50, check the dimensions and make your own decision if you want to proceed.

of course you can also use this on many many other bikes.. check the dimensions below and see if it'll work for you.

now features a blinding chrome finish!!

16mm diameter shaft

260mm total length

210mm length on the longer side

40mm length on the shorter side

26 tooth

taco rating taco rating 4 of 5

4 of 5 Total Reviews: 11 give your taco rating here

2 taco eaters like this review

Like the dude from 2016 said	August 1, 2021
taco eater : Eric from Portland, ME United States

Like the dude from 2016 said, the pedal chain keeps slipping off. Gives you the clearance you need, but at what cost? Bought the shaft extender instead. You should probably do the same

Was this review helpful to you?

0 taco eaters like this review

might work for a hobbit with some effort	April 19, 2021
taco eater : McSteve from Saint Paul, MN United States

Got this since it's same length/diameter as the shaft for my PA50. I'm pretty sure I'll make it work but be warned, it'll take some dickery. Sprocket has fewer teeth than original, but that's fine. The sprocket is a little further to the right side of the shaft than the original. Like the description says, you need moar spacer. Will need exactly the right amount of spacer on the right side. Too little and your crank arm won't clear your side cover. Too much and the sprocket will rub the cover. Probably also going to need a spacer on the left side to keep everything where you want it.

I shoulda just put a pull start and foot pegs on this fricken bike.

Was this review helpful to you?

0 taco eaters like this review

fixed pedal clearance on frankenstein brapper	July 2, 2020
taco eater : benji the boy

worked great to get my pedals clear of the za50 engine i have on a '78 maxi s (originally e50). make sure to get the plastic spacers!

Was this review helpful to you?

0 taco eaters like this review

So far so good	July 1, 2018
taco eater : Jim [s2m] from Lincoln, NE

Haven't had any issues with the pedal chain slipping and I do tend to use my pedals a lot, especially from a dead-stop. But also I just put a new pedal chain on it as well, so maybe that helps. Mounted stock pedal arms up to it with no issue. Seems to be holding up well so far.

Was this review helpful to you?

1 taco eaters like this review

Is it just me?	May 7, 2016
taco eater : Anonymous Person from Minneapolis, MN United States

I had an issue with the pedal chain slipping off the pedal crank on my pinto. It clears nicely as I was using it with my homoet 6p, but I couldn't pedal the bike as it would consistently slip off.

Was this review helpful to you?

View All Customer Reviews

treatland