malossi VL6 4 petal carbon fiber reed valve block

malossi VL6 4 petal carbon fiber reed valve block - carbonio

$45.00

:HERE NOW!!

qty:

for puch gilardoni kits, super good reed set up.

for peugeot malossi race case!

for AM6, derbi gpr, aprilia rs50, senda, derbi flat reed 4 petal setup!!!

if you're on the moped race team, hum?

removable stuffer, get stuffed, or don't, your choice!

carbon fiber body and reed valve seat

comes with reeds with a 0.3mm thickness

but if you want to experiment with different thickness reeds try these on for size

malossi part number 27 4235.C0

mounting holes are 63mm x 39mm

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 2 give your taco rating here

2 taco eaters like this review

Bye bye stink foot	March 8, 2016
taco eater : owen walker from La Mesa, CA United States

I couldn't get reeds on the stock Gila cage to seal very well even after 3 different blocks and lots of different reeds. The design of the stock block seems to make the reeds bend when you tighten down the screws. Anyway, slapped this little fucker in there and no more stink foot! Better performance all around! Now I can wear my moped shoes to church. Or are they my church shoes I wear on my moped? Fuck you, buy it.

Was this review helpful to you?

1 taco eaters like this review

Will fit NSR50R	September 16, 2015
taco eater : Thomas Haskell from Ansonia, OH United States

The elongated bolt hole pattern that is so common on the Malossi reed blocks like this one will fit a 2004 NSR50R. Along with the Derbi Euro engines, Aprilia AM6's, that its listed for. Just an FYI

Was this review helpful to you?

treatland