NOS minarelli V1 small end BRONZE bushing

$18.99

:*sorry none today*

qty:

new old stock original minarelli v1 small end crankshaft bushing!! with radical oiling grooves to promote lots o lubrication. note that these have an intentionally UNDER sized inner diameter so that once pressed in to the con rod, it can be reamed to spec. note there are no oiling holes drilled in this!

15.05mm OD
11.78mm ID
13mm long

part # 4470 on the diagram

taco rating taco rating 3 of 5

3 of 5 Total Reviews: 1 give your taco rating here

0 taco eaters like this review

Part is fine	June 2, 2022
taco eater : M from OH

Part is of good quality but does not fit any v1 engines I have around, strangely enough. O.D. of my original bearing/the crank surface is measuring just a hair over 16mm. This bushing is too small. Maybe it's for an earlier model than I have (78)

Was this review helpful to you?

treatland