taco eater :
Curtis Blubaugh from Naperville, IL United States
The intake itself will bolt onto your kit, but your SHA won't be able to go far enough back to seal, and it will hit the frame on the most common tomos. Oh almost forgot, cable routing on a bullet is absolutely impossible with this. It will look like shit 100% of the time because there's no sha adjuster shaped like the side of a tomos frame. The sha bendy cable adjuster sticks out in the opposite direction that you need it to go, and a straight one isn't even close to feasible because of the angle the carb has in relation to the frame. Oh and the carb has to run at a crazy angle in not one but TWO axes. Big disappointment
Was this review helpful to you?
0 taco eaters like this review
Good intake, bad screws
November 12, 2018
taco eater :
jason white from Stamford, CT United States
Intake is great, does a great job kicking carb out to the side for easier access. Do yourself a favor and replace the hex screws that come with this - they are hard to access and strip really easily
Was this review helpful to you?
0 taco eaters like this review
Quality part but not for your Colibri
April 2, 2018
taco eater :
Uncle Andy LSLB from Somerville, MA United States
lol like you have a colibri
ok but IF YOU DO this ain't gonna fit.
otherwise it's nice
Was this review helpful to you?
2 taco eaters like this review
ditch the side shooter intake
January 16, 2017
taco eater :
Will caldwell from san francisco, CA United States
seriously, they suck. 2 90 degree angles? super bobo flow
this mlm intake is SICK though. actual proper flow and shoots the carb conveniently to the side!!
no pedal clearance issues at all on an A35 bullet tt...unlike the a3 dude below me
Was this review helpful to you?
3 taco eaters like this review
nice but pedal hits carb
April 21, 2016
taco eater :
italian spiderman from Somerville, MA United States
Overall nice piece as usual from MLM, but the pedal doesnt clear my 15.15 with the air filter cover installed (just clears with no air filter). This is on an A3 with A35 top end so maybe that has something to do with it, but just making a note of it for others. May be able to trim some length off the end of the tube to clear or get bent crank arm/pedal shaft extender.
Doesn't fit at all 
Good intake, bad screws 
ditch the side shooter intake