taco eater :
Bogdan Balagurak from Ephrata, PA United States
Did not use in my Tomos cause piston didn't travel all the way up the cylinder.
Was this review helpful to you?
1 taco eaters like this review
Needs massaging
December 11, 2018
taco eater :
Murray Man 82 from Detroit , MI United States
Nice quality, lots of extra material to really open up some transfers BUT, the stud holes were a size too small and had to be drilled out with 1/4 bit for clearance. Easy peasy. Then it wouldn't fit over the kits skirt. So I dremeled it slowly a little at a time with a sanding drum. Then it was ready for case matching. These things are no big deal to someone who is familiar with mopeds and having to modify most things to fit. For someone just starting out this may be frustrating but a great learning experience as well.
Was this review helpful to you?
1 taco eaters like this review
does fine if you're willing to put in work.
July 18, 2018
taco eater :
Jonathan Feldman from Portland, OR United States
1. Yes you can case match em. Shit just takes forever. Make sure ya don't run outta material like the guy below. 2. I had to drill out the holes for the engine studs cause them shits were way too small.
It does the job but it def ain't a 10 min slap n go.
Was this review helpful to you?
0 taco eaters like this review
Not for case matching
April 30, 2016
taco eater :
Countryobtunning from Princeton , MA United States
You can not match these base spacers to your kit because you'll run out of material!
Was this review helpful to you?
1 taco eaters like this review
I think we just need a little space...
July 27, 2013
taco eater :
brian behrmann from st louis, MO United States
Need a Metrakit 65 base spacer? They measure 1.5 mm so a 1.6 mm spacer will fit just fine or you could go with a 1 mm or smaller spacer and get creative with your gasket paper and adjust the squish to whatever you want.
Spacer 
Needs massaging 
does fine if you're willing to put in work.