taco eater :
Marshall Reinhart from Louisville, KY United States
Yes! Currently rocking it on my general v1. Running stock cylinder for now and it's a ripper. Going to be super duper awesome once I toss on the 80 Polini and vm18.
Was this review helpful to you?
0 taco eaters like this review
Demm Powah
May 7, 2020
taco eater :
Malcolm Browne from Maine
Rips on a Demm Smily! Just make a little bracket!
Was this review helpful to you?
1 taco eaters like this review
Great Pipe
February 15, 2015
taco eater :
Generalissimo from charlotte, NC United States
Sounds great. Noticeable power improvement. looks cool. Tight fit though, could barely get the nuts on. Also, if you are getting this for a Lazer or General - DON'T FORGET TO BUY THE MOUNTING BRACKET like I did.
Was this review helpful to you?
0 taco eaters like this review
nevermind
September 11, 2014
taco eater :
Anonymous Person
Was this review helpful to you?
0 taco eaters like this review
Will not work with Autisa kit
June 11, 2014
taco eater :
Cpt. F from Seattle, WA United States
Can not be used with the Autisa 55cc kits. The header is too large to get hex nuts on the exhaust studs, which are cast permanently into the kit. Bummer. Might work for other cylinders with allen blots instead of studs.
Also, doesn't even come close to mounting at the rear bracket on a Baretta Magnum.
Otherwise seem really well built and nicely finished.
Is it worth it? 
nevermind 
Will not work with Autisa kit