taco eater :
Alexander Landerman from BLOOMINGTON, IN United States
I was worried it wouldn't work with the stock subframe but bolted up perfectly and now my little leg is safe from my TJT. Stoked on this part really wish it was aluminum cause its heavy af.
Was this review helpful to you?
0 taco eaters like this review
super cool if your plan is to set it and forget it
December 27, 2020
taco eater :
Hobbit Master Pike from SARASOTA, FL United States
I purchased this to save my toes from being eaten by the TJT variator! With the Proma pipe set up I added a washer to the top and side screws to compensate for the tab on the Proma pipe. Works great except for the fact that I needed the pedal crank extender thingy so the pedal arm would clear the guard! (not because of the washers/Proma pipe mounting tab) MLM should offer one in this kit, one that is about half the length of the one that is sold here so the pedal doesn't stick way out. Also, a major improvement to this guard would be instead of using long screws or bolts, make the plate separate from the tubes, turn the tubes into studs so that they can be mounted to the engine/sub frame then have the plate bolt or screw into the ends of the studs! Then its super easy to remove only the plate to tune/service the whole variator/bell assembly. So, similar in design as the contra brace dealio. This would make it a 6 or 7 taco maybe even a 10 taco rated part if it was aluminum!
Was this review helpful to you?
0 taco eaters like this review
Doesnt clear pedals - need spacer
March 12, 2018
taco eater :
Eames from Tustin, CA United States
Very well made. Bolts are the same thread as the stock ones.
It just barely doesn't clear my pedals as is so i just needed a spacer for my pedal shaft and reduced the spacer on the sprocket side. clearance is now SUPER tight but it passes it makes the variator side look 1000x better.
now we just need something for the chain side please MLM.
Works on stock subframe 
super cool if your plan is to set it and forget it