MLM fork brace for EBR HYDRAULIC forks

MLM fork brace for EBR HYDRAULIC forks - DOUBLE

$64.99

alternate reality price $59.99

:HERE NOW!!

qty:

***ATTN*** this most recent batch is slightly off square, so you should either enbiggenize the mount holes or get your hammer and be ready to spend some quality time with this brace. price reduced to reflect this minor defect

MLM steel fork brace specifically for the EBR hydraulic forks!!!

also works with these telescopic (non-hydraulic) forks!!

finished in a beautiful black powder coat!

this is the DOUBLE version. double = extra stiffffy

78mm between the two mounting tabs
100mm across where the tire passes through...should easily fit a 2.75in tire
6mm holes work perfecto with the m6 bolts that come ebr hydros
18mm spacing between the mounting holes

taco rating taco rating 4 of 5

4 of 5 Total Reviews: 2 give your taco rating here

0 taco eaters like this review

it's okay	April 17, 2017
taco eater : andy swoops from Atl

v stiff and the welds are nice but I think MLM should remeasure their jig, mine's a little warped so if you bolt it on without washers in between of the mount holes it pulls the fork tubes in and locks up your front end.

Was this review helpful to you?

0 taco eaters like this review

Show Bike Parts	May 26, 2015
taco eater : Aaron Fogg from Memphis, TN United States

Super stiff doesn't describe this enough. It does not flex at all. Clean welds, glossy powdercoat, sweet plugs on the bottom holes to finish it off.

Was this review helpful to you?

treatland