taco eater :
RICHARD CAMACHO from Union, NJ United States
I just purchased one of these cdi kit for my 1979 garelli grand sport of course I ran into a few problems the flywheel dosent have a slot for the wooddruf key so flywheel spins know I have to add extra washers to tighten the flywheel in place, there's no timing Mark's on the flywheel.
Was this review helpful to you?
2 taco eaters like this review
Noi 1sp. have your dremel ready
October 1, 2017
taco eater :
JD from Lincoln, NE United States
This stator is bigger than the stock points stator. Had to cut away the lip on the engine case for the new stator to seat correctly and not rub on flywheel. Definately not just bolt and go, at least not on my ssxl noi single speed. There's also no way to adjust the timing by just leaving the stator screws a little loose and rotating to adjust, then tightening after the flywheel is on as they say in the instructions because the edge of the flywheel is directly over the screw heads. In the end I finally got it shredding and yes quite an improvement, but alot of work.
Was this review helpful to you?
1 taco eaters like this review
Blasting on a 2 speed NOI!
May 14, 2017
taco eater :
Peter T. from Chicago, IL United States
Finally took the initiative to get my two speed running and decided to pop this on. easy bolt up, well made hardware, and simple to time. Bright lights and strong spark as well! If you have a reliable Garelli Definitely a good but expensive investment.
Cdi problems 
Noi 1sp. have your dremel ready 
Blasting on a 2 speed NOI!