HPI CDI mini rotor ignition system for morini M1, M01, & M02
HPI CDI mini rotor ignition system for morini M1, M01, & M02
 
  $259.00

 :HERE NOW!!

Free Shipping
qty:

 
 
new HPI CDI mini rotor ignition for morini m1, m01, & m02!! should fit fine on any of these engines with CEV ignitions. might fit on M101, i can't remember, someone remind me if you can?

this version has an integrated 60W light coil for super bright lights!! great curve and comes with all you need to make the change.

uses a 27mm x 1mm left hand thread puller!!!!!

always use a resistor boot or resistor plug when running a cdi or you run the risk of burning up your cdi box!

the trail tech voltage regulator works the best with the mini rotor!

the stator may be black, red or gold, whichever color HPI sends out. its not something we can choose, so its not something you can choose either.

these now come with two leads along with the cdi harness off the stator. the yellow with with the ring terminal is grounded and the other yellow wire with a female spade connector goes to lights!

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Installed for a customer September 23, 2021
taco eater : Adam Riggsby from allston, MA United States  
A customer brought me an m02 sebring with this ignition on it. He had it timed wrong, but to no fault of his own. I did some research and found that some of the HPI mini rotor flywheels have timing marks 90º off of where they should be.

check this out if you have issues with your HPI and setting timing

https://hpi.be/downloads/wrong_rotor_batch_en.pdf

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 It's Alive! It's Alive! November 4, 2020
taco eater : Ken from Minneapolis, MN United States  
Trying to get a "liberated" Motomarina Sebring running. After I cracked the stator and couldn't find a replacement, I bit the bullet and got the HPI CDI system. Instructions are sparse but correct. And it works! Now all I have to do is figure out how to wire in the kill switch and lights.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Works amazing!! April 4, 2019
taco eater : Aaron Vigil from Sheridan,WY  
I finally got my moped running thanks to this little guy definitely simplified things!

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 Fits on M101 February 4, 2015
taco eater : Decker from Minneapolis, MN United States  
Just wanted to let everyone know that this also fits an M101. I have not used it yet but it fits.

Was this review helpful to you?