6001 moped sealed wheel bearing

6001 puch moped sealed wheel bearing + hobbit clutch bell!!

$9.99

:HERE NOW!!

qty:

bearing for sealed bearing moped wheels and honda hobbit clutch bells!! radddddd and oh this just in, also for honda MB5 transmission (remove seals)!

puch, peugeot? aaahhhhhhhhh.. . ..measure first or feel the pain if wasted $$, for sure the stock replacement on puch five star front and puch rear and front spoked.

for honda MB5 you need two of these for a complete rebuild.

we only carry high quality SKF, NKE, FAG or NTN C3 clearance bearings.

28mm OD
12mm ID

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 4 give your taco rating here

0 taco eaters like this review

fits perfectly in a hobbit clutch bell	May 22, 2013
taco eater : Ryan Nash from Columbia, MO United States

heat the bell up, stick a screw driver through and tap on the edge of the spacer (SOFTLY!) and it should push the bearing out. put the spacer back in, heat up the bell again and slap the new bearing in with the side without the seal facing in (seal side facing out). voila... new bearing... happy hobbit bell!

Was this review helpful to you?

0 taco eaters like this review

Not quite for 5 stars	June 9, 2011
taco eater : michael cohen from Medford, MA United States

These were 1mm off on my gold 5 stars. Used some .5mm shim stock and was good to go.

Was this review helpful to you?

1 taco eaters like this review

Works with a shim	October 7, 2010
taco eater : Joel Kvernmo from seattle, WA United States

On the Puch spokers I had they had an ID of 29mm. So if you get .5mm stainless steel shim material these will fit perfect.

Was this review helpful to you?

2 taco eaters like this review

pa50/hobbit vario bearing!	July 20, 2010
taco eater : Justin from Renofrancisco, CANV United States

Also fits your hobbit variator (and pulleys for you unvariated people)! This is the inside bearing. Just remember to pop off one of the seals before you press it in.

Was this review helpful to you?

treatland