puch ZA50 clutch side case bearing + puch snowflake wheel bearing

puch ZA50 clutch side case bearing + puch snowflake wheel bearing - 16101 - RUBBER seal

$15.99

:HERE NOW!!

qty:

this is the smaller of the two bearings that are embedded in the clutch side of the ZA50 case, you know what i'm sayin. so there are two different puch ZA50 clutch side covers with different size bearings. so be aware. check the measurements. depends if you have the ZA50 with oil injection or no oil injection. ok. more details to come.

16101

30mm OD
12mm ID

these come as sealed bearings. if you are using this for a ZA50 case, make sure to pop off the plastic seal before you put it in the case.

apparently you can use these to convert puch snowflake wheels from loose bearing to sealed bearing! you'll need to use a 12mm axle. ive never tried this, a myth? maybe. some one please confirm. and ALSO take note that snowflakes usually use a different size bearing in the front and in the rear. read up on the puch snowflake sealed bearing conversion here and here.

these also work perfecto for front hobbit 5 star wheels to convert them over to 12mm axles instead of the lame-o 10mm ones!! score!

** If this is out just look here for other brands! easy! **

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 6 give your taco rating here

1 taco eaters like this review

Perfect fit on Puch Snowflake rear	April 17, 2014
taco eater : Michael Santos from San Francisco, CA United States

Fit perfectly in the bearing cup without needing a shim. Huge improvement over the stock loose bearing setup

Was this review helpful to you?

0 taco eaters like this review

Snowflake isn't direct fit, needs shim	May 28, 2013
taco eater : Tall Kyle from Chicago, IL

Snow flakes measure out at 31mm and these are 29.88mm.

you will need a shim for it to work, just a heads up to people.

Was this review helpful to you?

2 taco eaters like this review

Fits snowflake REAR wheel	May 5, 2013
taco eater : EDWARD MANHART from OMAHA, NE United States

A bit pricey, but is a direct fit to rear snowflake wheels. 3 out of 3 times this has fit, match with 12mm axle that comes with spacers.

Was this review helpful to you?

0 taco eaters like this review

FOR 12MM CRANK	July 3, 2012
taco eater : Ryan Piccirillo from Allston, MA United States

The bearing is useless to me, but is totally fine! This is for the 12mm crank (the oil injected engine). If this is not the engine you have, get the 16100 - that is the one with the 10mm ID. That is the one you want. Not this one. This is not the bearing you're looking for. Just added this info to the MA wiki. Can't believe it wasn't already there.

Was this review helpful to you?

0 taco eaters like this review

funky five stars fix	November 21, 2011
taco eater : Buck from Dayton, OH

This also will work on a set of puch 5 stars if you have some weird dimensions. Don't just take my word on it... measure you goof!

Was this review helpful to you?

View All Customer Reviews

treatland