taco eater :
DAS Riot from Detroit, MI United States
Let us know when you guys can get those rear clutches sold separately! Morini clutches (which can work on Vespas as well) have full circle pads, 90mm cheeks, shift dampeners, and take Tomos/ZA clutch springs.
Was this review helpful to you?
0 taco eaters like this review
fast and torkey
January 21, 2016
taco eater :
princess rapunzel from santa cruz
hauls my fat butt around with the kit and a GPR zen well. 14sha is quite limiting though. I can tell it wants to wind out higher, but can't....
Was this review helpful to you?
0 taco eaters like this review
Yay!!I finally got one of these!!
June 25, 2014
taco eater :
DaveZilla from San Antonio, TX United States
I'll put this bad boy to the test and report back...
Was this review helpful to you?
1 taco eaters like this review
mmmmmm
April 8, 2012
taco eater :
Morgan from Oberlin, OH United States
taco eater :
Chad Burke from Kalamazoo, MI United States
This is the same bottom end essentially as the morini M101, but with a vertical cylinder and larger ports. Should be interesting to see how this performs with the Malossi 45.5 kit. Now if you could only find a stockpile of M101 engines which were also used on the motobencane Hobby.
Rear Variators! 
