One-off custom expansion chamber for Lambretta LD!
July 5, 2021
taco eater :
Patrick McManus from Gloucester, ON Canada
I had an exhaust shop fabricate a custom header to mount this pipe on my Lambretta LD150 scooter, for which there are very few performance parts available. Works like a charm, breathes better than the stock tin box of rust exhaust. I might need to have the header tweaked a bit as clearance is a little low on right turns.
You Do need to coat this thing regularly, though unless you like rust-coloured exhausts.
Hold on to your pooter when second gear hits, cruises comfortably at 45 then some if you push it.
Was this review helpful to you?
3 taco eaters like this review
Rips at high rpm
April 26, 2013
taco eater :
Samuel Drupiewski from El Dorado Hills, CA United States
Welded to a 28mm maxi header. The header slides into the pipe perfectly. Hits hard at around 30 then takes off like a whore on meth! Pedal arm needed to be extended over an inch to clear and I mounted the pipe TIGHT next to the swingarm.
Was this review helpful to you?
3 taco eaters like this review
Killer pipe for the $
January 7, 2013
taco eater :
Max Ramos from Ames, IA
mounted up with the puch 28mm header. 30.5 tuned length to hit down low. BEASTLY LOW END on a puch airsal 72. mounted on a Maxi N. pedals clear, stand clears, no worries baby. if it dont fit, you're doin in wrong.
One-off custom expansion chamber for Lambretta LD! 
Sweet bearded baby jesus